Sketch Template

Use the following sketch as a template when creating patches for the Episodes. Create an effects chain in the GUI and copy the GUI-generated code where specified in the template. Add variables and functions etc where specified. See my Creating Patches article for more info.

#define LED 3
#include <Bounce.h>

// copy and paste the GUI generated code here

Bounce footswitch = Bounce(0, 50);  // debounce the footswitch
Bounce D1 = Bounce(1, 50);          // debounce the toggle switch
Bounce D2 = Bounce(2, 50);          // "  "  "  "  "  "  "  "  "

// this section includes the function to check the toggle position
bool right;
bool middle;
bool left;
void checkToggle () {               // this is our function to check toggle position...
D1.update();  D2.update();          // check digital inputs connected to toggle (can delete I think)
if(digitalRead(1) && !digitalRead(2))   {right = 1; middle = 0; left = 0;}    // toggle is right
if(digitalRead(1) && digitalRead(2))  {right = 0; middle = 1; left = 0;}      // toggle is in the middle
if(!digitalRead(1) && digitalRead(2))   {right = 0; middle = 0; left = 1;}    // toggle is left
}

// declare your variables here

void setup() {
 
  AudioMemory(40); // the "40" represents how much internal memory (in the Teensy, not the external RAM chip) is allotted for audio recording. It is measured in sample blocks, each providing 2.9ms of audio.
  sgtl5000_1.enable();    // this turns on the SGTL5000, which is the audio codec on the audio board
  sgtl5000_1.volume(1);   // this sets the output volume (it can be between 0 and 1)
  sgtl5000_1.inputSelect(AUDIO_INPUT_LINEIN); // selects the audio input, we always use Line In
  analogReadResolution(12); // configure the pots to give 12 bit readings
  pinMode(0, INPUT_PULLUP); // internal pull-up resistor for footswitch
  pinMode(1, INPUT_PULLUP); // internal pull-up resistor for toggle
  pinMode(2, INPUT_PULLUP); // internal pull-up resistor for toggle
  pinMode(3, OUTPUT);       // pin 3 (the LED) is an output;
  Serial.begin(9600);       // initiate the serial monitor. USB is always 12 Mbit/sec

  sgtl5000_1.adcHighPassFilterDisable();
  sgtl5000_1.audioPostProcessorEnable();
  sgtl5000_1.audioPreProcessorEnable();
  sgtl5000_1.autoVolumeEnable();
  analogReadAveraging(32);  

  // write any code you want to use once ("set and forget") here
  
}

void loop() {
  
  // call functions for controlling parameters with pots/footswitch/toggle here

}